AT88RF001 datasheet pdf

1 Features •13.56 MHz ± 7 kHz RFID Interface for Multi-chip Cards and Tags •Electrically Compatible with ISO/IEC 14443-2, Type B •Serial Channel Configurable to Communicate with External Chips •Supports SPI and Two-wire Serial EEPROM Interface •320 Read/Write EEPROM Bits, Divided into 10 Pages of 32 Bits •Password and Write Lock Protection •Programmable Send Protocols •Integrated Tuning Capacitor •ID Length Programmable from 4 to 18 Bytes •Optional 2-byte CRC Description The AT88RF001 is a stand-alone 13.56 MHz RFID front end that includes a serial port suitable for connection to an external high-density serial memory. Using the on-board EEPROM, it can be configured to communicate using various protocols and interface to both two-wire and SPI external devices. The device contains 320 bits of full read/write EEPROM memory and offers features such as passwords, locking and a variable-length ID. It is electrically compatible with ISO/IEC 14443-2, Type B. The IC includes an internal tuning capacitor; only an exter- nal coil antenna is required to complete the RFID channel. The serial channel is configurable to communicate with external ICs using either two- wire or four-wire (SPI) serial channels, at a maximum speed of 106 kilobits per second (Kbps). An external bypass capacitor will be required to filter and stabilize the supply generated by the RFID front end. Up to 2 mA can be drawn by the external memory when communications are not occurring. Figure 1.Block Diagram The AT88RF001 is intended to be used with serial EEPROMs such as Atmel’s AT24Cxx two-wire line or its AT25xx SPI line. In addition, it can communicate with an external microprocessor if more complicated systems are to be built, if software on that processor can model the slave protocol of the corresponding memories. It is expected that a single external memory chip will be connected to the AT88RF001. EEPROM Serial Clock Chip Select Data Output Data Input VSS VDD Clock Extraction Data Modulation Control Regulator Bridge Rectifier RFID External EEPROM Interface IC AT88RF001 Rev. 1943F–RFID–04/02

Features

• •13.56 MHz ± 7 kHz RFID Interface for Multi-chip Cards and Tags
• •Electrically Compatible with ISO/IEC 14443-2, Type B
• •Serial Channel Configurable to Communicate with External Chips
• •Supports SPI and Two-wire Serial EEPROM Interface
• •320 Read/Write EEPROM Bits, Divided into 10 Pages of 32 Bits
• •Password and Write Lock Protection
• •Programmable Send Protocols
• •Integrated Tuning Capacitor
• •ID Length Programmable from 4 to 18 Bytes
• •Optional 2-byte CRC